T-slot Aluminum Profiles

Product control of speed

The Sigma Profiles

Aluminium sigma profiles cover cuts in different external sizes and channel series. This page brings together general sizes groups while each product code is...

Konveyör Şase Profilleri

The carrier shase profiles are special cuts used in the side body of the transport line and in the connection mode. For band, crossing, roll or cover connection, the carrier is a...

The corner connectivity

The corner connector elements help to preserve geometry at the points where sigma profiles are combined. the contact area on the profile of the connection and the contact area on the profile of the connection.

Internal and internal connections

Internal and subsequent connective elements are assessed to reduce the area that the profile combination covers on the external surface. The combination method is at the end of the profile.

Channel and Cave

The channel shells and shells use the channels on the sigma profile as a link point. The size of the tooth alone is not enough; the body of the shell is the same as the shell.

Connecting Boxes and Plakets

Connector boxes and plates are used to connect or support profile combinations over a surface. The two, three or four directions are...

Profile coverings and channel fits

Profile coverings and channel fits help complete open ends and unused channel parts. The end closing and the end closing along the channel...

The Closes, Closes and Closes

The shell, the curves and locks work together in the open parts of the sigma profile cabins. The weight of the door, the direction of opening and the frame geometry of the accessories...

Adjusted legs and wheels

Adjusted legs and wheels allow the profile shakes to sit or move on the ground. The need to change the place with a fixed use, the subconnection, the...

Panel, Plexi and Glass Holders

Panel, plexis and glass holders are used to connect the sheet elements to the profile structure. The material of the sheet, thickness and connectivity sides are...

Sigma Profile Cutting and Processing

Sigma profile cutting and processing is the preparation stage that forms the construction’s assembly dimensions. In addition to the size cutting, the hole, the tooth or the connection...

Sigma Profile Six and Constructions

Sigma profile shades and structures are structures where the cuts are combined with the connective elements. Machine board, protective cabin and work...

Connecting equipment

Connection equipment creates the connective points of the profile shade. The external corner, the channel or the gate connection requires different assembly rows; cutting and...

Connecting accessories

Connection accessories complete the profile skeleton with details such as door, panel, foot and cable. To ensure that mobile and fixed parts do not collide with each other...